Intelligent Torque Output is a smart management system that allows the ESC to adjust the motor for inclines or descent under any load to match the throttle.

U-matched hill-hold function
With 8 levels of drag brake force (Power) and 9 levels of Drag Brake Rate, drivers can fine-tune their vehicle’s hill-holding power and general driving. Overall, drag brakes can be 2 times stronger than normal brushless setups.

Designed for Durability
Silicon rubber gaskets, electronic buttons, and quality hardware ensure a long life for the Fusion SE. Made to take the abuse and conditions of daily RC bashers.

Ready for all weather and track conditions
IP-67 waterproof rating ensures the Fusion SE has protection from water, dust, and about anything else that gets thrown at it. Designed to withstand all conditions time and time again.

Note: The IP67 protection level mentioned above is splash-resistant, water-resistant and dust-resistant under normal use, and is tested under controlled laboratory conditions. Its effect is in the GB / T 4208-2017 (domestic) / IEC 60529 (overseas) standard to IP67 level. Splash, water and dust resistance are not permanently effective, and the level of protection may decline due to aging. Do not soak for a long time to avoid damaging the product.

Specifications:
Type: 1/10 Brushless, Sensored, Waterproof (IP67) ESC & Motor Combo
Cont./Peak Current: 40A
Input Voltage: 2-3S Lipo/6-9 Cell NiMH
BEC Output: 6V/7.4V @ 4A (6A peak)
Motor KV: 1200KV
Diameter/length of Motor: 36mm / 58.1mm
Shaft diameter / exposed shaft length: 3.175mm / 16.5mm
Motor Poles: 4
Firmware Upgrade: Not Supported
Size: 36X58.1mm
Weight: 201g (including wires & connectors)
Application: 1/10 Rock crawlers

Wires & Connectors:
Input Wires: 14AWG-200mm
Input Connectors: XT60

ESC Programing via:
SET Button on ESC: Not Supported
LED Program Box: Supported
LCD Program Box: Not Supported
OTA Programmer: Not Supported
Program Port: Independent programming interface (switch position)